JTAG Flashing Wire

Electronics
1

image
image1001×483 75.7 KB

I’m a bit confused on the steps to make this flashing wire. Did you not use pin headers on the ‘-’ indications and instead just ignored those connections?

2

Hi Emilia,

yes, these connections are ignored / not connected.

Best,
Julian

1 Like
3

@Emilia
Some tips as we had some issues with this operation last week.

  • Be careful to check the documentation of your JTAG board, the JTAG pin order is standard but there might be jumper to install.
  • The schematic of the Connector MicroDriver (right) is made looking down/at on the MicroDriver.
  • You can check the GND with a multimeter from the JTAG board to the MicroDriver to troubleshoot your wiring.
  • The lenght of the cable is indeed best kept short as mentionned in the doc.
1 Like